TheEpicBirb's latest activity
-
i’m no expert but simply by vibe: short tail feels correct for the size of the plane? and the new nose wheel placement feels much... -
TheEpicBirb replied to the thread 3D printed 1:400 stuff I make :).thanks! the short tail does feel correct by the vibe, but it works a lot better on the 737-100 i designed. i never knew how stubby the...
-
TheEpicBirb replied to the thread 3D printed 1:400 stuff I make :).funnily, that short tail was ALSO from a blueprint I found, but I think that blueprint is incorrect since thats where I pulled this long...
-
Here's the start of a new 1:400 scale hypothetical regional airport. This airport consists of ground level gates as well as airstair...
-
TheEpicBirb replied to the thread 3D printed 1:400 stuff I make :).how tall do you think it should be? it matches the blueprint that I used to shape out the fuselage 🤷♂️
-
TheEpicBirb replied to the thread 3D printed 1:400 stuff I make :).not sure which tail looks more accurate. I feel like its the taller one but at the same time not
-
-
-
-
TheEpicBirb replied to the thread 3D printed 1:400 stuff I make :).all thats left is to make the tail more accurate!
-
-
-
-
-
TheEpicBirb replied to the thread 3D printed 1:400 stuff I make :).I see, thanks a lot! ill fix it now :)
-
TheEpicBirb replied to the thread 3D printed 1:400 stuff I make :).heres the side profile :) it matches the blueprints that I had used hmmmmm thanks for the advice ill adjust it if required (y)
-
-
